System installed with new style inner and outer tie rods.

Install almost complete. P/S/ lines and intermediate shaft to be connected yet.

Lifting in cross member looking at the driver side. R&P is already attached to the cross member.

This is looking at the drivers side while installing the 1/2 inch grade 8 bolt.

Here is the bottom of the steering column being removed on a late 67 steering column. This is best done with the steering column out of the car because of the work needed to install the adapter sleeve.

 With the steering column adapter in place you can either drill a small hole and put in a screw to secure the adapter or you can weld to column and the adapter together. If you drill make sure to remove all metal particles that were produced.

 Picture of steering column, intermediate shaft and rack installed